Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Park Slope?
Garage door work in Park Slope typically costs $150 – $600 for a repair, and most repair jobs land in the $180 – $340 range when a spring or cable is the culprit. A new door installation runs about $700 – $2,200, and a single opener replacement is usually $250 – $550 installed. Those are typical estimated ranges for this market, not a final number. The written estimate sets the price, and we give you that estimate free before any work starts.
Our technicians have up to 14 years of experience, and they work on the hardware actually sitting in your garage: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. No second vendor for the opener, no guessing at parts. We answer 24/7, and fast dispatch runs 7am to 7pm, Sunday through Friday. Call (855) 765-9251 for a free estimate.
Key Takeaways
- Most Park Slope garage door repairs fall between $150 and $600.
- Spring repair is $180 – $340 for one spring; a matched pair is about twice that.
- New door installation runs $700 – $2,200 depending on size, material, and insulation.
- Brooklyn brownstone and row-house garages often mean tight clearances and old framing, which shapes labor more than the parts do.
- Estimates are free. The written estimate sets the final price.
Garage Door Cost Breakdown (2026)
Here’s what the common jobs cost in Park Slope. These are typical estimated ranges for the neighborhood, and the written estimate you get on-site is the number that counts.
| Service | Typical Estimated Range |
|---|---|
| Garage Door Repair (general) | $150 – $600 |
| Spring Repair (one spring) | $180 – $340 |
| Cable Repair | $130 – $250 |
| Opener Repair | $120 – $320 |
| Opener Installation | $250 – $550 |
| Panel Replacement | $250 – $500 |
| Track Realignment | $120 – $240 |
| Roller Replacement | $110 – $220 |
| New Door Installation | $700 – $2,200 |
A note on springs, because this is where homeowners get surprised: the spring ranges above are for one spring. Torsion systems almost always use a matched pair, and when one spring breaks the other is usually near the end of its life. So a pair is typically about twice the single-spring range. Replacing both at once is standard practice, not an upsell.
What pushes a bill toward the top of a range? A broken torsion spring on a heavy wooden door, a bent track that needs realigning before anything else can move, or an opener job where the motor is fine but the logic board or safety sensors need replacing. What pulls it down? A single snapped extension spring, a set of worn rollers, or a cable that let go without dragging the door out of square. Those tend to be quick, clean jobs.
What Affects Garage Door Pricing in Park Slope
Park Slope isn’t a generic suburb, and the housing stock here changes how a garage door job goes. Here’s what moves the number:
- The building, not just the door. A lot of Park Slope garages sit under brownstones or attach to pre-war row houses. That often means low headroom, older wood framing around the opening, and a door that was fitted to a non-standard size decades ago. Oddball dimensions mean custom panels, which cost more than off-the-shelf.
- Which brand is already installed. We work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor, so we’re not improvising around your hardware. But parts availability for an older Craftsman opener differs from a current LiftMaster unit, and that can shift the opener repair range.
- Torsion versus extension springs. Torsion springs, common on heavier and more modern doors, take more skill and slightly more time than extension springs. That’s a big part of why spring repair holds the $180 – $340 band rather than dropping lower.
- Whether it’s an emergency. A door stuck open on a Park Slope street is a security problem, not just an inconvenience. We treat emergency garage door service as a real, named offering, and same-day calls get scheduled like any other job. The price is set per job by the written estimate; urgency doesn’t add a surcharge.
- Manual versus opener-driven. If your garage is manual now and you want an opener added, that’s an opener installation ($250 – $550) plus whatever the door needs to run safely, like balanced springs and straight tracks.
- Weather and seasonal wear. Park Slope’s freeze-and-thaw cycles through winter work metal hard. Springs fatigue faster, cables fray, and rollers dry out. A door that creaks and drags in February often needs roller or track work by spring.
Repair or Replace: Which Makes Sense in Park Slope?
Repair is usually the right call when the door structure is sound and the problem is mechanical: springs, cables, rollers, tracks, or the opener. Replace when the door itself is failing, meaning cracked or rotted panels, a bent frame that won’t straighten, or a size and style that no longer fits how you use the garage.
The math is straightforward. If a repair lands near the bottom of the $150 – $600 range and the door is otherwise solid, repair it. If you’re staring at panel replacement ($250 – $500) plus track realignment plus a new opener, and the door is already old, you’re putting real money into a door that’s near the end of its life. That’s when installation at $700 – $2,200 starts to make sense, because you’re getting a door that’s balanced, insulated, and matched to your opening.
One thing we won’t do is push a replacement you don’t need. If a spring repair and a set of rollers get you another decade, that’s the answer. Our full repair range, from a snapped spring to a full new installation, is covered on our garage door repair flatbush page, and we’ll tell you honestly which side of the line your door is on.
What a Typical Garage Door Job Involves
When you call, we ask what the door is doing. Won’t open, won’t close, opens halfway and stops, makes a bang, hangs crooked. That tells us a lot before anyone arrives, and it helps us bring the right parts for your brand.
On-site, the technician checks the full system, not just the obvious failure. Springs, cables, rollers, hinges, tracks, and the opener’s safety reverse. A door that won’t close is sometimes a sensor problem and sometimes a balance problem, and you want the actual cause. Then you get a written estimate with the price for each item, and you decide. If you approve, the work happens, often the same visit for common repairs.
A word on safety, and we mean this. Garage door springs and cables are under extreme tension and can cause serious injury if handled without the right tools and training. Torsion springs in particular can release violently. We don’t give step-by-step instructions for adjusting or replacing them, and we’d ask you not to try. This is exactly the kind of work our spring repair specialty exists for. Leave it to a trained technician.
How to Save on Garage Door Work in Park Slope
You can’t avoid a broken spring, but you can keep a small bill from becoming a big one:
- Get the free estimate first. There’s no charge to look at the door and write up the price. Call (855) 765-9251 and get the number before you commit.
- Fix the spring before it takes the door with it. A tired spring left alone can distort tracks and burn out the opener motor. A $180 – $340 spring repair is cheaper than a spring plus a track realignment plus an opener repair.
- Replace springs in pairs. It feels like spending more up front, but two springs replaced together outlast one spring replaced twice, and you avoid a second service visit.
- Lubricate and check the door yourself. A little lubrication on rollers and hinges, and a listen for grinding or scraping, catches wear early. That’s safe, DIY-level maintenance.
- Ask about the opener before replacing it. A lot of “dead” openers just need a sensor alignment or a logic board. Opener repair at $120 – $320 beats replacement at $250 – $550 when the motor’s still good.
- Match the door to the job. A basic steel door at the low end of the $700 – $2,200 install range does everything a fancy one does for a Park Slope garage. Spend on insulation and fit, not on features you won’t use.
FAQs – Garage Door Cost in Park Slope
How much does garage door repair cost in Park Slope?
Most garage door repairs in Park Slope run $150 – $600, with common jobs like spring or cable repair landing around $180 – $340. The written estimate sets the final price. Call (855) 765-9251 for an exact quote, and the estimate is free.
How much does spring repair cost in Park Slope?
Spring repair is $180 – $340 for one spring. If your door uses a matched pair, which most torsion systems do, expect about twice that since both springs are typically replaced together. We’ll confirm the setup on-site and put it in writing. Call (855) 765-9251 to book a free estimate.
How much does a new garage door cost in Park Slope?
A new garage door installation runs $700 – $2,200 in Park Slope, depending on size, material, and insulation. Older row-house garages with non-standard openings can push toward the higher end because they need custom-fit panels. Your written estimate nails down the number, and it’s free. Call (855) 765-9251.
Is it cheaper to repair or replace a garage door?
Repair is cheaper when the door is structurally sound: plan on $150 – $600 versus $700 – $2,200 for replacement. Replacement makes more sense when panels are rotted or cracked and you’d be stacking panel replacement on top of track and opener work. We’ll give you both numbers and let you decide. Call (855) 765-9251 for a free estimate.
How much does opener repair or installation cost in Park Slope?
Opener repair is $120 – $320, and a new opener installed is $250 – $550. We service LiftMaster, Chamberlain, Genie, and Craftsman openers, among others, so we’re diagnosing the actual unit in your garage. Call (855) 765-9251 and we’ll get a free estimate on the books.
Get Your Free Garage Door Estimate in Park Slope
Whether it’s a snapped spring, a door that won’t close, or a full replacement you’ve been putting off, the next step is simple: get a real number. Call (855) 765-9251 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. One call covers repair, opener work, spring repair, installation, and emergency service, so you’re not juggling vendors. Estimates are free, pricing is upfront, and the written estimate sets the final price.
Pricing reflects the Park Slope market as of 2026. Garage Door Repair Flatbush offers free estimates – call (855) 765-9251.
Written by the team at Garage Door Repair Flatbush.
What Our Customers Say
"Good repair, reasonable money. The door still has a slight shudder about a foot from the top that he said is the track being slightly out of true on an old frame and would cost real money to fix properly. Fair enough, but I'd hoped it would be perfect."
- Veronica Martinez"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
- Neil Reddy"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Devon Grant